- Notes, Cautions, and Warnings
- Introduction
- Using Lifecycle Controller
- Operating System Deployment
- Monitor
- Hardware Inventory View and Export
- About View and Export Current Inventory
- About View and Export Factory-Shipped Inventory
- Viewing Hardware Inventory—Current or Factory-Shipped
- Exporting Hardware Inventory—Current or Factory-Shipped
- Viewing or Exporting Hardware Inventory After Part Replacement
- Viewing and Exporting Current Inventory After Resetting Lifecycle Controller
- Lifecycle Log
- Firmware Update
- Configure
- System Control Panel Access Options
- Configuring iDRAC
- Configuring System Time And Date
- Configuring vFlash SD Card
- Configuring RAID
- Configuring RAID Using Software RAID
- Creating a Secure Virtual Disk on Series 8 Controller
- Key Encryption
- Local Key Encryption Mode
- Breaking Mirrored Drives
- System Setup-Advanced Hardware Configuration
- Collect System Inventory on Restart
- Configuring Local FTP Server
- Configuring Local USB Drive
- Maintain
- Troubleshooting and Frequently Asked Questions
- Lifecycle Log Schema
- Easy-to-use System Component Names
- Using The System Setup and Boot Manager
Dell Lifecycle Controller 2 Release 1.4.0 User's Guide
Launching Lifecycle Controller
To start Lifecycle Controller during the system start, press the <F10>key within 10 seconds after the manufacturer's or service provider’s logo is displayed. When Lifecycle Controller is started for the first time, it displays Settings wizard that allows you to configure the preferred language and network settings.
- NOTE: If the system does not enter Lifecycle Controller, see Launch Messages Causes and Resolutions .
Related concepts
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please provide ratings (1-5 stars).
Please select whether the article was helpful or not.
Comments cannot contain these special characters: <>()\